Technical information

1) On all drawer units the drawers are 270mm deep no matter what the depth of the unit ie. a 500mm deep drawer unit will only have 270mm drawers.

2)There is a 45mm service void at the back of all units except drawer units.

3)Base units are 720mm high plus 140mm for the plinth and 30mm for the worktop.

4)Wall units are 575mm high and 720mm high with 10mm service void at the back.

5)Mid height units are 1440mm high plus 140mm for the plinth and 30mm for the worktop.

6)Tall units are 1825mm high using a 720mm bottom door (or drawers) and a 720mm top door plus 140mm for the plinth.

7)The depths of the units stated is the depth of the carcass. The depth of the door needs to be added to this which is generally between 18 and 23mm.

8)All units have full adjustment on the hinges and hinge plates to allow complete flexibility if the alignment goes out of square during transit. Full instructions on how to do this can be viewed by clicking the fitting instructions link below.

Tips

1)When cutting out the fascia for your basin make sure you allow the 30mm height of the worktop in your calculation so as not to cut 30mm too much off the fascia.

2)The furniture that we supply is resistant to moisture, however it is important that any excess dampness that remains on it is removed with a hand towel.

Drawer box instructions